| |
|
| |
|
|
Corona Dope
|
 |
|
(ADH) 10-4702
GC Electronics Corona Dope. Reduce or eliminate corona and arcing! This cellulose resin based, black lacquer has excellent dielectric, arc, and corona resisting properties. It protects surfaces against moisture, dries quickly, and insulates up to 325°F. Used on flybacks, coils, and transformers to improve the insulation and weather-resistant properties of wires. High dielectric strength of 3000 volts/mil. Add as many layers as needed. Glass bottle comes with brush applicator. 2 oz. bottles. 12 bottles per carton. 8 cartons per case. Reduced for clearance.
• Tesla applications
• High voltage sharp points
• HV power supplies
• Flyback transformers
• Copier machines
• CRT circuits
|
|
|
Loctite Adhesive Threadlock
Type 222 - Low Strength |
 |
(ADH) 22231
Use Loctite 222 where occasional adjustments of small fasteners
may be required. Small hand tools can be used to overcome the adhesive seal. Best
for 1/4” and smaller fasteners. Temp. range: -65º to 300ºF (-54º to 149ºC).
Partially cures in 30 to 60 minutes, full cure
in 24 hours.
Bottle marked "Use by 10/02" WE ARE SELLING A 50ML BOTTLE FOR THE SAME
PRICE OTHERS ARE SELLING A 10ML BOTTLE!! |
|
| $4.95 ea - $4.50 (3+), $3.99 (12+), $3.49 (144+) |
|
|
|
|
|
|
|
White Silicone
Heat Sink Compound |
 |
(ADH) CT40-1
High performance silicone grease formulated for high heat
transfer applications including thermo-couple wells and mounting power devices. Meets
Mil-C-47113. 1 oz. tube. |
|
|
PureTronics
Circuit Freeze |
 |
(ADH) PT-7400
PureTronics Circuit Freeze helps locate
thermal intermittent defective resistors, transistors, capacitors, semi-conductors
and other electronic components. It also provides heat sink protection for heat sensitive
components during soldering and desoldering conditions and helps locate cold solder
joints and PCB cracks. Chills to -62ºF, non-flammable, zero residue, ozone safe.
10 oz. can. |
NOTE:
Aerosol cans CANNOT be shipped Internationally. |
|
| |
|
|
PureTronics
Cleaner / Degreaser |
 |
(ADH) PT-3200
PureTronics Cleaner / Degreaser is an
excellent strength non-flammable cleaner for electronic, electrical and industrial
components and equipment. Chemically stable, quick penetrating, low surface tension
action formulation. Removes oils, grease, grime, dirt, silicones, fluxes and
other contaminants. Evaporates moderately quick leaving zero residue. 19 oz.
(1 lb, 3 oz.) 538g.
Applications: Contacts, controls, switches,
relays, connectors, sockets, circuit breakers, solenoids, rheostats, potentiometers,
motors, generators, metal parts, electronic components, electrical equipment,
avionics and more. |
NOTE:
Aerosol cans CANNOT be shipped Internationally. |
|
|
PureTronics
Value Duster |
 |
(ADH) PT-7000
PureTronics Value Duster is an economical
high powered duster developed for general purpose type applications. A special
blend of 134A and DME offers the necessary blasting power to remove microscopic
contaminates like dust, lint, dirt, oxide particles and other dry contaminants.
Delivers up to 70 psi blasting power. Helps in the evaporation of slow drying
cleaning solvents. 10 oz., 283g.
Applications: Electronic components and
equipment, audio / video equipment, electrical equipment, photographic equipment,
printed circuit boards, timers, computers, keyboards, printers, office machines
and more. |
NOTE:
Aerosol cans CANNOT be shipped Internationally. |
|
| |
|
|
Pure Tronics
Contact Cleaner |
 |
(ADH) PT3000
High tech contact cleaner restores electrical continuity
of contacts and effectively cleans surrounding areas. Removes oils, greases, grime,
dirt, silicones, fluxes and other similar soils. Evaporates quickly, leaving ZERO
residue. Safe on plastics and metal materials. Ozone friendly containing no CFCs
or HCFCs. 5.5 oz. |
| $3.99 each |
| |
|
(ADH) PT3500
13.25 oz. |
NOTE:
Aerosol cans CANNOT be shipped Internationally. |
|
|
2 Part Epoxy |
 |
(ADH) CTXY30
The finest epoxy available; formulated for gap-filling bonds
between a variety of substrates. Two parts, just squeeze a dab or pile, mix with
stick (included) and apply. Bonds in 60 minutes to handle, 24 hours cures to completion.
3.2 oz. |
| $3 each |
| |
| |
|
| |
|
|
RTV
One-Part Compounds |
 |
Surplus Sales
stocks four grades of one-part silicon RTV, varying in viscosity, tensile strength,
elongation percent and temperature range. Each is available in 2.7 oz. tubes or 5.3
oz. cartridges for dispensing guns. |
CT137 Great general purpose sealant,
adhesive, insulator, etc., of dissimilar materials. Translucent, thixotropic, low corrosive,
room temperature curing, odorless mixture may be applied overhead and on side walls.
Meets Mil-A-46106
Type 1. |
(ADH) CT137-3
2.7 oz. tube |
| $2 each |
| |
|
(ADH) CT137-6
5.3 oz. cartridge |
| $4 each |
| |
|
| CT238 Similar to CT137 above
but also meets Mil A-46146 Type I. Especially suitable for corrosion resistant electrical/electronic
applications. Higher tensile strength, elongation, temperature range. |
(ADH) CT238-3
2.7 oz. tube |
| $3 each |
| |
|
(ADH) CT238-6
5.3 oz. cartridge |
|
|
RTV
One-Part Compounds |
 |
Surplus Sales
stocks four grades of one-part silicon RTV, varying in viscosity, tensile strength,
elongation percent and temperature range. Each is available in 2.7 oz. tubes or 5.3
oz. cartridges for dispensing guns. |
| CT240 Similar to CT238 but also
meets Mil I-46058C Type SR, Mil-I-A46146 Type II. Especially suitable for corrosion
resistant electrical/electronic applications like conformal and surface coatings on
boards, encapsulation, shock isolation and lens coating. Quick skin time. Exceptional
dielectric properties. |
(ADH) CT240-3
2.7 oz. tube |
| $3.50 each |
| |
|
(ADH) CT240-6
5.3 oz. cartridge |
| $7 each |
| |
|
| CT345 Meets Mil A-A46146 Type III.
Excellent heat stability. Suitable for silicone rubber repair and other connector /
component mending jobs. Our highest grade RTV available. |
(ADH) CT345-3
2.7 oz. tube |
| $5 each |
| |
|
(ADH) CT345-6
5.3 oz. cartridge |
|
| |
|
|
Silicon Lubricant |
 |
Surplus Sales
stocks two types
of silicon lubricating compound. |
| CT11 Metal to Non-Metal silicone
penetrating lubricant. Superior to other products on the market. Stable from -40 degrees
fahrenheit to 400 degrees fahrenheit. Non-melting, water repellant, corrosive resistant,
high dielectric strength. Translucent color. Excellent for sealing vacuum and pressure
systems. Compatible with rubber and plastic o-rings, gaskets. Worked penetration of
200-300mm. |
(ADH) CT11-1
1.25 oz. squeeze tube. |
| $2 each |
| |
|
(ADH) CT11-5
5.3 oz. squeeze tube. |
|
|
Silicon Lubricant (cont'd) |
|
Surplus Sales
stocks two types
of silicon lubricating compound. |
| CT44 High temperature silicone
grease performs well in metal to metal applications but is compatible with ceramic,
glass, silicone resins, and painted surfaces. Stable from -40ºF to 400ºF.
Non-melting, moisture, corrosion and oxidization resistant, high dielectric strength.
Amber color. Excellent lubrication for motor bearings, appliances and PCB fabrication
jobs. |
(ADH) CT44-1
1.25 oz. squeeze tube. |
| $3 each |
| |
|
(ADH) CT44-5
5.3 oz. squeeze tube. |
|
| |
|
|
Spray Adhesive |
 |
(ADH) CT1688
Great stuff, multi-purpose, pressure sensitive, high
strength, quick tacking spray, adhesive formulated for industrial use. Not for
wimps. Adjustable bond strength - temporary or pemanent. Giant 16 oz. can, Excellent
for bonding foam, woods, metals, felt, cloth , cork, leather, cardboard, rigid
plastics, etc... |
NOTE:
Aerosol cans CANNOT be shipped Internationally. |
|
|
Battery Terminal
Protection Compound |
 |
(ADH) RMCP
Eliminate battery problems forever! Helps prevent power loss,
condensation, corrosion, oxidization and erratic operation on all battery powered
devices like water timers, remote controls (no more pounding on the coffee table),
garage door transmitters, cameras, flashlights and so on. Goop gel on contact and
battery terminal then forget it. 1/4 oz. tube contains dozens of applications. |
|
| |
|
|
Wire Tack |
 |
| Wire tack for quick mount of components,
wire, strain relief. Withstands thermal shock from solder. Cures with UV light in just
seconds. Available in two syringe sizes plus 180 ml gun tube. |
(ADH) CTUV912-10
10 ml syringe |
| $4 each |
| |
|
(ADH) CTUV912-30
30 ml syringe |
| $9 each |
| |
|
(ADH) CTUV912-18
180 ml cartridge |
|
|
2 Part RTV |
 |
(ADH) CT5184-2
Clear, high strength RTV well suited for deep section potting,
sealing, encapsulating and mold making. Both parts in main tube and mixes without
mess. Install nozzle, place in SEALANT GUN for application. Total elapsed time need
not exceed 5 minutes. CLEAR 2.5 oz. |
| $7 each |
| |
|
(ADH) CT4120-2
RED, 2.5 oz. |
| $10 each |
| |
|
(ADH) CT4110-6
WHITE, 6 oz. |
|
| |
|
|
RTV Primer |
 |
| CT1200: Not required
for RTV's but increases adhesion on most substrates encountered. Two sizes available. |
(ADH) CT1200-1
1 oz. bottle, liquid |
| $3 each |
| |
|
(ADH) CT1200-4
4 oz. bottle, liquid |
|
|
Conformal Coating |
 |
 |
| UV cure (Ultra-Cure)
one-part conformal coating forms a clear glossy coat that sticks to ceramics, plastics,
metals, glass, etc... Expose to high intensity ultraviolet light for cure. Manufacturer
suggest reading and understanding MSDS Technical Data Sheet prior to use. |
(ADH) CTUV984-30
1 oz. syringe |
| $4 each |
| |
|
(ADH) CTUV984-25
8.45 oz. bottle |
|
| |
|
|
SMT Adhesive |
 |
| CTUV996 is an electronic grade
urethane acrylic specifically engineered for surface mount applications. Use it as
an adhesive or sealant to achieve thick or thin coatings to mount resistors, connectors,
bond wires / terminals etc... |
(ADH) CTUV996-30
30 ml syringe |
| $7.50 each |
| |
|
(ADH) CTUV996-10
10 ml syringe |
|
|
Peelable Mask |
 |
| CTUV945 One part thixotropic peelable
mask. Withstands thermal shock from solder. High strength in thick or thin applications.
Cures with ultraviolet light. Use for masking of solder and conformal coatings. 5.3
oz. Cartridge for dispensing gun (shown above) |
(ADH) CTUV945-30
30 oz. syringe |
| $5 each |
| |
|
(ADH) CTUV945-18
180 ml cartridge |
|
| |
|
|
Dessicant Dehydrating
Silica Gel |
 |
(ADH) PROTEK-SORB
Dessicant dehydrating silica gel. Reactivates @ 240º - 260ºF. "4 unit" bags. |
|
|
|
|
|
| |
