Fans & Blowers: Miscellaneous Stuff
** ALL STOCK NEW, UNUSED **
Fan Blade
(FAN) 1210
4 blade fan. 1/2" bore, 10" diameter.
$15 each
Axial Fan /
Propeller
High Quality
(FAN) 2031510
McGraw Edison Co. axial fan / propeller. High quality. Four blade. 4" x 5/8". 1/4" bore, 2 set screws.
$10 each
Aluminum Fan Blade
(MOT) FAN
Aluminum fan blade. One set screw. 2-1/2" diameter. 0.197" bore, 0.343" shoulder. This fan blade is typically used to self cool a motor.
$3 each - $2.50 (6+)
Air Flow Sail Switch
(SWM) B8100
Autron air flow sail switch. 1PDT microswitch. 3-3/4" overall height, 4" insertion (2-1/8" sail). NSN: 5930-00-451-5750.
$35 each
Conductive Woven
Shielding Gasket
Shielding Gasket
(FRI) 4400B1477
Lockheed conductive woven shielding gasket. Makes a great "RF" proof washable air filter. 4.96" x 2.6". 0.18" compressed, 0.25" un-compressed. NSN: 5999-925-9535.
$15 each - $12 (3+)
Air Flow Switch
SPDT
(SWM) E51-00E
Cherry air flow switch. SPDT. Spring arm included. No sail.
$12 each
70 CFM HEPA Filter
8" x 8" x 6-3/4"
(AHD) 87000834-2
Cambridge Filter Corp high efficiency
(99.97%) replaceable HEPA filter box has rubber gasket on each face. 8" square
x 6-3/4" deep.
$39 each - $33 (3+)
Air Duct Hoses
(ADH) 8A08CH046
2" diameter x 15-1/2" long Flex-Fab mil-spec, helically
wound with one continuous wire support, circular air duct for routing cooling air for
equipment. Will turn sharp radius without losing form.
*** SOLD OUT ***
(ADH) 8A12CH104
3" diameter x 30" long, otherwise as above.
$32 each
(COL) 009-1804-050
5" diameter x 48" long, otherwise as above.
$50 each
Air Duct Hoses (cont'd)
(ADH) AERODUCT
Aeroduct air duct hose. Helically wound - continuous wire support. 1-1/2"D x 18"L. Red.
$19 each
(ADH) 009-1468
Flex Fab air duct hose. Mil-spec. Helically wound - continuous wire support. 2"D x 19"L. Black.
$22 each
(ADH) 009-1804
Flex Fab air duct hose. Helically wound - continuous wire support. 2-1/4" x 13"L. Black.
$27 each
Shielded, Wire Impregnated
Clear Plastic Lens
Clear Plastic Lens
(PLS)
SCRNWIN-1
Peek in on the glow of your finals
through this RF proof plastic
lens without letting the signals escape. Full size is 7-15/16" x 4-3/16".
Notice our close-up shot of the fine wire screen so small you can't even see it from 12" away. 1/4" wide perimeter gasket.
$22 each
RF Honeycomb Screen
(COL)
753-0270-001
RF honeycomb screen. 6-1/4" x 21" x 3/4" thick.
26 mounting holes penetrate front to back. 60 dB attenuation. Threaded #8 mounting holes. Made from ultra
strong T6063 aircraft aluminum. No holes will show on
outside. Braid and rubber compression gaskets for air and RF tight
seals. Perfect size to incorporate one or two into chassis, side by side
or stacked. 60 dB attenuation.
Keeps the RF signals in while moving air in or out of the chassis. Shielded intake screens for amplifiers make no air noise, have no back pressure. RF compression and rubber gaskets for RF tight seal.
Keeps the RF signals in while moving air in or out of the chassis. Shielded intake screens for amplifiers make no air noise, have no back pressure. RF compression and rubber gaskets for RF tight seal.
$95 each
(FRI) 60-71326
2-3/4" x 8" x 3/4" thick. Mounts from rear with six threaded #8 holes. Otherwise, same as above.
*** SOLD OUT ***
|
|||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||
|
|
|||||||||
|
||||||||||
|
|
||||||||
|
|||||||||
|
|
||||||||
|
|||||||||
|
|
||||||||
|
|||||||||
|
|||||||||
|
|||||||||
